In this video, I tried to configure Remote Access IPSec VPN through command-line. It is only base configuration to establish a tunnel between ASA and Cisco VPN client. When I have time, I will continue where I left off. Actually in the next video I am gonna add NAT 0 rule and configure NAT on routers (to show ipsec-over-tcp), vpn filter, and Client U turn.
PART 1
PART 2
PART 3
I was thinking that I could attach initial configurations as a txt file. But I couldn't. So, what I configured on ASA and routers before recording the video is only some ip addresses and default routes to provide ip connectivity.
No comments:
Post a Comment